We are proud to announce that the most popular Anet printers are now supported in the Unified Firmware! This includes support for EZABL and Stock machines. You can get the latest release from here: TH3D Unified Firmware
Use the “OpenWindowsFirmwareAnet.bat” file to flash the firmware. If you want to use the latest Arduino IDE you need to flash your bootloader then you can use the newer Arduino IDE included.
***If your Anet board resets when trying to flash you will need to flash the bootloader. Pinout is on the firmware page for the programming header. We recommend using a USBASP for this. You can get one from Amazon below (TH3D does not carry USBASPs)***
Anet Bootloader Flashing Guide: https://www.youtube.com/watch?v=k4w_qAsAwlM
USBASP: http://amzn.to/2FiqUNH
10 to 6 Pin Adapter: http://amzn.to/2CzBKMr
- Anet A2
- Anet A6
- Anet A8
- Anet E10
- Anet E12
The EZABL Direct Wire kit works with all these models and will get you leveling in no time! If you just want to upgrade your machine with some shiny new firmware you can also update to the Unified Release to get some new features and safety protection. Our firmware has hotend and bed protection so that if something goes wrong with either heater it will shut the machine down and not cause a fire.
Thank you to Pete from the Anet group for helping out with getting all the printer configurations dialed in for everyone.