EZBoard V2.X Board Firmware
Do you have our EZBoard V2 and are looking to compile firmware on your local computer?
If you don’t require special configurations or want to setup VSCode you can always use our EZFirmware website to compile for you free of charge to all EZBoard customers.
This firmware supports all printers that the EZBoard Lite supports.
What printers are supported?
- CR-10 (Regular, Mini, S4 S5)
- CR-10S (Regular, Mini, S4 S5)
- Does NOT work with Touch Screen Models
- Ender 2
- Ender 3
- Ender 3 Pro
- Ender 3 V2
- Needs LCD swapped. See here for details: Ender 3 V2 – Swapping to the 12864 Creality LCD for more features – TH3D Studio LLC
- Ender 3 MAX
- Ender 5
- Ender 5 Pro
- Ender 5 Plus – Needs other addons/upgrades listed below
- Needs the 12864 LCD Conversion Kit
- Does NOT work with the stock Touch Screen, only with the 12864 LCD Conversion linked above
- Sovol SV01
1 – Printer Board Firmware Update
1.b – Download the firmware
1.c – Extract the files to a folder on your computer
1.d – Open the folder labeled “Firmware” in VSCode
1.e – Open the Configuration.h file that is located under the “Marlin” folder on the left side of the VSCode screen
1.f – In the Configuration.h file, uncomment (remove the 2 / in front of #define) the printer you are using and any other options you are going to use in the firmware
1.g –Click the ✓ at the bottom of VSCode to compile the firmware. The firmware will compile. This may take 1-5 minutes depending on the speed of your computer and internet connection
1.h –On the left side of VSCode expand “.pio” until you see the TH3D_EZBOARD_V2 folder. Right click on the TH3D_EZBOARD_V2 folder and click “Reveal in File Explorer”
1.i –In the file explorer open the TH3D_EZBOARD_V2 folder
1.j –Look for the latest firmware.bin file and copy that to your SD card. This SD card must be FAT32 formatted.
1.k –Power OFF your printer and Insert the SD card with the latest firmware.bin file into your printer. Turn the printer on. It will take a little longer than normal to boot up.
1.l –When the printer boots you will see the TH3D logo on your LCD. Make sure to reset your EEPROM on your printer after flashing any firmware. You can do this from your printer LCD or by sending a M502 followed by M500 with your favorite Gcode sender application.
THIS FIRMWARE AND ALL OTHER FILES IN THE DOWNLOAD ARE PROVIDED FREE OF CHARGE WITH NO WARRANTY OR GUARANTEE FROM TH3D STUDIO LLC. SUPPORT IS NOT INCLUDED JUST BECAUSE YOU DOWNLOADED THE FIRMWARE.
TH3D STUDIO LLC IS NOT LIABLE FOR ANY DAMAGE TO YOUR PRINTER, PERSON, OR ANY OTHER PROPERTY DUE TO USE OF THIS FIRMWARE. IF YOU DO NOT AGREE TO THESE TERMS THEN DO NOT USE THE FIRMWARE.
We do not maintain a full change log for this firmware. However, you can track all changes and modifications to our firmware code on the GitHub repo for Unified 2 Firmware.