Print

EZPi – Image Download (All Versions)

Reloading the EZPi Image

In the event, you want to start over or you break the EZPi with a plugin or change and it will not boot again you can restore the factory image by removing the MicroSD card from the EZPi and “burning” it to the SD card again. The flashing tool is for a Windows PC. We have not tested imaging from Mac or Linux.


Image Download

You are welcome to use this on your own Pi but this is provided AS-IS with NO warranty or support for non-EZPi customers. Requires a 16GB MicroSD or larger. The EZPi Pro Image is intended for use with the Pi 4B boards but does work on the older 3B and 3B+ boards as well.


Pre-Loaded Plugins and Backend Installed Apps

Our EZPi image contains a curated selection of pre-installed and pre-setup plugins to make your experience better with our EZPi kits. We also pre-install some backend applications that normally require you to SSH into the Pi to install them.

Plugins

*Check Changelog below as these plugins were added after the initial V2.0 release.

Additional Apps/Programs

  • AVRDUDE – For Flashing Firmware on 8-bit printers

Changelog

  • V2.4 – 8/3/2021
    • Built on Octopi 0.18.0 Image Base
    • Updated all plugins to their latest releases as of 8/3/2021
    • TSD Plugin Removed as default installation due to picamera not installing bug on image creation
      • Install the TSD plugin through the plugin installer if you wish to use it with the EZPi.
  • V2.3 – 7/8/2021
    • Built on Octopi 0.18.0 Image Base
    • Updated to Octoprint 1.6.1
    • Updated all plugins to their latest releases as of 7/8/2021
    • New image built with CustoPiZer for a “Clean” Image
      • SSH Keys, API Keys, Password Hashing Salt, Cookie Secret, and SSL Self Signed Cert are all generated on boot with the new image generation format so each instance has a unique ID
      • This was done to prevent possible issues if users do not heed warnings against port forwarding to their EZPi setups.
    • Safe mode 1st boot bug fixed
  • V2.2 – 4/29/2021
    • Built on Octopi 0.18.0 Image Base
    • Updated to Octoprint 1.6.0
    • Updated all plugins to their latest releases as of 4/28/2021
    • Added Autoselect Plugin
    • Added Babystep Z -/+ buttons to Terminal Tab
  • V2.1 – 3/31/2021
    • Built on Octopi 0.18.0 Image Base
    • Updated Firmware Updater to 1.10.10
    • Changed Arc Welder Plugin to Manual Processing by default
  • V2.0 – 3/29/2021
    • Built on Octopi 0.18.0 Image Base
    • Initial V2.0 release

Flashing Tools

Recommended Flashing Tool: https://www.balena.io/etcher/ 

Alternate Flashing Tool: https://sourceforge.net/projects/win32diskimager/


SD Card Removal Tools (Printable)

Previous EZPi – Host Action Commands Warning
Next EZPi – Static IP, Hostname, & Camera Options
Table of Contents