The BigTreeTech wiring harness for the BL Touch uses completely non-standard colors for the wiring. Below is a picture showing the 2 side by side with what color on the BTT harness is equal to the AntClabs one.
The Creality wiring harness for the BL Touch uses non-standard colors for the wiring. Below is a picture showing the 2 side by side with what color on the Creality harness is equal to the AntClabs one.
If you have the stock Creality metal bracket for your BL Touch then the offsets are -44 on X and -9 on Y. If you are using our Unified firmware then enter this into the CUSTOM PROBE section after you uncomment the CUSTOM_PROBE mount option in your printer section. See the BL Touch section in […]
Intro The Creality V4.2.2 and V4.2.7 boards have a dedicated 5 pin header on the board that can be used for the Creality BL Touch kits. You can also use 3 of those pins and the Z endstop port if you have the 3+2 pin wiring harness. Our Unified 2 firmware is setup to use […]
Not sure where or how to update your starting code? Check out our slicer article for updating your starting gcode. To ensure the proper intended operation of our EZABL kits you must be on the latest firmware and use the starting code below. This code is entered into your slicer and is executed before the print […]