What you will need The EZNeo Strip Plug it in! The Octopus Pro boards have a dedicated NeoPixel header. This pin is pre-setup in Marlin 2.0 and uses pin PB0. Just simply plug in the EZNeo cable to the RGB header on the board shown below in the pinout diagram and the other end of […]
DISCLAIMER This firmware is being put out as a courtesy for people who want to use the BTT SKR 2 in their custom printer. Setup and usage of this firmware is *not* covered under the technical support of any TH3D Products. Using the BTT SKR 2 in a custom printer is an advanced setup for […]
What you will need The EZNeo Strip Plug it in! The SKR 2 boards have a dedicated NeoPixel header. This pin is pre-setup in Marlin 2.0 and uses pin PE6. Just simply plug in the EZNeo cable to the RGB header on the board shown below in the pinout diagram and the other end of […]
DISCLAIMER Before we start we want to note that during testing to get this LCD working with the EZBoard we had one instance where the BTT TFT LCD killed the CPU on the EZBoard. Our engineer has also had stability issues with the BTT TFT LCD itself and its firmware. This information is provided as […]
The BigTreeTech wiring harness for the BL Touch uses completely non-standard colors for the wiring. Below is a picture showing the 2 side by side with what color on the BTT harness is equal to the AntClabs one.
- 1
- 2