EZPi – EEPROM Datasize error

This error occurs when you do not reset your printer EEPROM after updating the firmware. This should be done every time you update the firmware on your machine. Note: Clearing the EEPROM will reset custom settings that you have entered in. If you have custom settings (example: z offset, steps/mm, acceleration, jerk, etc) these will be […]

Simplify3D – Not Connecting to Printer over USB

Intro One thing we noticed is that on some machines Simplify3D will start to connect but then stop. This is usually caused by the firmware serial start command not matching exactly what Simplify3D is looking for. The easiest way to get around this is to just uncheck the firmware start check by following the steps […]