On our EZPi images, we bundle the BetterHeaterTimeout plugin. This is a handy plugin to shut off the heaters when idle in case you forget but there is a bug in the plugin that is a show stopper. If you have a filament sensor and the machine is paused it will kill the print job […]
Overview The Creality V4.X.X boards have 2 different ways to connect the EZOut filament sensor to them with our kits. One uses our LCD adapter header board and the other uses our standard version board. Both achieve the same end result, adding a filament sensor to the printer, but they connect differently and have different […]
Intro The Ender 3 V2 LCD is currently limited by its closed source firmware. You can remove the stock LCD and replace it with the Creality OEM LCD and a printed part. Once the LCD is swapped you just flash the printer as an Ender 3, not an Ender 3 V2. This works with the Creality […]
The CR-10S with the touch will work with the EZABL however there are a few differences with the setup. Since the touch LCD does NOT support setting the Z offset or Babystepping you cannot do it without a computer. EEPROM: To reset the EEPROM send M502 followed by M500 You can set the Z offset with Gcode and […]