Fixing a Bad Bootloader If for some reason you got a bad flash on your 2560 based board you can always bail yourself out by re-flashing the bootloader with an Ardunio Uno kit and then uploading the firmware. To do this follow our bootloader flashing guide but instead of selecting the “Sanguino 1248p” for the board select the “Arduino […]
Steps to Flash over an UNO If you find yourself with a board with a bad USB port you can use an Arduino UNO to flash the firmware. Follow the steps below: Setup the firmware as normal Make sure the “ArduinoISP” sketch is loaded on your Arduino UNO Connect the UNO to your board ICSP […]
Does the EZBoard Need Heatsinks on the Drivers? No. Because we properly design our boards unlike the Chinese. They do not need heatsinks and TMC specifically states that there are to be NO heatsinks on their drivers since they sink heat through the PCB. Our board is 4 layers with 2oz copper on EVERY layer. […]