EZBoard V2 – Installation Guide

Getting Started Welcome to the TH3D EZBoard V2 Documentation! Almost everything is plug-and-play. Make sure to unplug your printer from the wall before installing this or any other parts on your printer. We will cover the connections on the board and then go over adding things like filament sensors, EZABL, and BL Touch, all optional […]

EZOut Filament Sensor Kit – Installation Information

Getting Started You will need the following to install the kit: The TH3D EZOut V2 Kit If you have the Standard (SKR/MKS/Tornado/CR-10S)/Wanhao D6 a heat gun or hair dryer to install the heat shrink on the adapter PCB after making the connections Tools to open your control box PC To Flash the Firmware Unified 2 […]

EZABL Pro Installation Guide

Welcome to the EZABL™ Pro kit installation guide! This guide will walk you through the steps to install the EZABL™ Pro sensor on your printer. Be sure to follow all the steps and if you have issues or a question, do not hesitate to reach out to us by visiting ContactUs.TH3DStudio.com. There are optional accessories […]