EZABL Pro™: M119 End-stop Test

What is the M119 command? Marlin’s M119 command is called “End-stop States”. This reports the current status of each end-stop switch (and filament sensor, if present) at the time it is run. The data is retrieved by the printer and output to a terminal connected to the printer. The data typically looks like the following: […]

Z Not Showing “TRIGGERED” M119 Test

Issue  If your Z Endstop is not triggering this could be due to a manufacturer wiring configuration on your Z endstop connector. The EZABL board has been set up based on testing of multiple machines that we have in house. But after sending out many kits it appears that the wiring that manufacturers use are […]