What you will need The EZNeo Strip Plug it in! The SKR 2 boards have a dedicated NeoPixel header. This pin is pre-setup in Marlin 2.0 and uses pin PE6. Just simply plug in the EZNeo cable to the RGB header on the board shown below in the pinout diagram and the other end of […]
Overview We have board-specific setup guides in the help center, this guide is for general, universal guidance to power, wire, and set them up with any Marlin-based printer. Using them in a universal application will require some soldering to provide power and firmware changes. The EZNeos need a 5V DC power input and a signal […]