Simplify3D – Not Connecting to Printer over USB

Intro One thing we noticed is that on some machines Simplify3D will start to connect but then stop. This is usually caused by the firmware serial start command not matching exactly what Simplify3D is looking for. The easiest way to get around this is to just uncheck the firmware start check by following the steps […]

Dual Extrusion Setup Information

Intro When doing dual extrusion there are many ways to go about it. The basic requirements are that you have a board that supports 2 Extruder connections, 2 hotend connections, and 2 hotend thermistor connections. However, if you are using a 2 into 1 adapter you only need a board that has 2 extruder connections. […]