DIY Firmware | BTT SKR 2 Board | BETA

DISCLAIMER This firmware is being put out as a courtesy for people who want to use the BTT SKR 2 in their custom printer. Setup and usage of this firmware is *not* covered under the technical support of any TH3D Products. Using the BTT SKR 2 in a custom printer is an advanced setup for […]

EZNeo – SKR 2 Board Setup

What you will need The EZNeo Strip Plug it in! The SKR 2 boards have a dedicated NeoPixel header. This pin is pre-setup in Marlin 2.0 and uses pin PE6. Just simply plug in the EZNeo cable to the RGB header on the board shown below in the pinout diagram and the other end of […]