Y Layer Shifting on Your Printer

There have been a few dozen reports on forums, reddit, and our communities about issues with the Y layer losing steps and shifting on the CR-10 machines. Mainly on the S4 and S5 machines. This can happen on stock machines and modified ones running the Unified Firmware. Common Factors Cura Version 3.4.x and above Can […]

Dual Extrusion Setup Information

Intro When doing dual extrusion there are many ways to go about it. The basic requirements are that you have a board that supports 2 Extruder connections, 2 hotend connections, and 2 hotend thermistor connections. However, if you are using a 2 into 1 adapter you only need a board that has 2 extruder connections. […]