Board Connections These board connections apply to the V2.0/V2.1/V2.2 Creality Board Versions. BL Touch Wiring
Fixing a Bad Bootloader If for some reason you got a bad flash on your 2560 based board you can always bail yourself out by re-flashing the bootloader with an Ardunio Uno kit and then uploading the firmware. To do this follow our bootloader flashing guide but instead of selecting the “Sanguino 1248p” for the board select the “Arduino […]
What you will need The EZNeo Strip A 5V Power Adapter Jumper Wires Soldering Iron & Solder IO Pin Wiring The V2.X (V2.0, V2.1, V2.2, V2.2.1) boards have 2 IO pins that are available to use. You can use any of these to control the EZNeo strips. Below is a picture showing the pin locations […]