Unified 2 Firmware – Github Repo and Old Versions

This article briefly describes how to obtain and use our Unified Firmware packages from our Github source, as well as how to use it to compile your firmware. Please note that you should always be using the latest version of Unified Firmware and the instructions available from our site for your specific model/mainboard for the […]

VSCode: Check-mark Compile Button Not Showing

Before we begin… You should have VSCode, PlatformIO, and Python installed according to these instructions. You can also use Marlin’s instructions for installing the software (up to the “Setting your Environment” section). PlatformIO is an extension of VSCode used for all Marlin-based firmware. It must be installed properly before firmware can be compiled. PlatformIO should […]

EZBoard V2.X Board Firmware

Do you have our EZBoard V2 and are looking to compile firmware on your local computer? If you don’t require special configurations or want to setup VSCode you can always use our EZFirmware website to compile for you free of charge to all EZBoard customers. This firmware supports all printers that the EZBoard Lite supports. What printers are supported? […]

VSCode – “No such file or directory” Error

Sometimes when compiling for the 1st time you may get an error that says “No such file or directory”. This can be caused by your Antivirus interfering with the file creation or VSCode’s timing for getting the libraries set up was off. To fix this just wait 1 minute and then try the compile or […]