What you will need The EZNeo Strip A 5V Power Adapter* Jumper Wires Soldering Iron & Solder *These boards have a 5V output but we do not recommend using that to power the EZNeo as we do not want to overload the 5V rail on these boards. It is recommended to supply a separate 5V […]
These are older LCD adapter boards for Ramps 1.4 boards included with some LCD orders from the factory, while needed to connect the LCDs to Ramps 1.4 boards, they have no use on any recent board like Creality, MKS, or BigTreeTech.
Overview The Creality V4.X.X boards have 2 different ways to connect the EZOut filament sensor to them with our kits. One uses our LCD adapter header board and the other uses our standard version board. Both achieve the same end result, adding a filament sensor to the printer, but they connect differently and have different […]
Getting Started Welcome to the TH3D EZBoard V2 Documentation! Almost everything is plug-and-play. Make sure to unplug your printer from the wall before installing this or any other parts on your printer. We will cover the connections on the board and then go over adding things like filament sensors, EZABL, and BL Touch, all optional […]
Fixing a Bad Bootloader If for some reason you got a bad flash on your 2560-based board, you can always bail yourself out by re-flashing the bootloader with an Arduino Uno kit and then uploading the firmware. To do this, follow our bootloader flashing guide but instead of selecting the “Sanguino 1248p” for the board, […]