P.I.D. Auto Tune Guide
What is P.I.D. Tuning?
PID (Proportional Integral Derivative) is the system the printers use for holding a set temperature. This system controls how fast the printer reaches the set temperature and how well it holds that temperature once it gets there. Without it numerous problems can arise. Fortunately for us, the printer has an automatic way of tuning these values.
Welcome to the TH3D P.I.D. Auto Tuning Guide! This will take you through the steps to P.I.D. Tune your printers hotend. If you have the new Unified Firmware you can go to Control > Temperature > PID Autotune > Then set to 240 if you have a stock hotend and 250 if you have an all metal. See pictures below for the LCD option with the new Unified firmware. This will go through the process AND apply the PID settings automatically. You will need to either select Control > Store Settings or send M500 to store them even when using the LCD.
There are a few ways to do so, we will be using Pronterface included in the firmware download package. To find this go to the firmware download > Extra Programs > GCode Sender > GcodeSender program. You can also get it here: GCode Sender – Pronterface
Plug your printer in and make sure ALL other programs are closed. Find the Port droplist and select the Port COM number your printer is using as well as setting the correct Baudrate (115200 for Creality printers, 250000 for Most others) and hit the connect button.
On the right side of Pronterface is the Terminal window. Use the command M303 E0 S225 C10 to start the P.I.D. Auto Tuning. This will P.I.D tune the printers hotend(E0) to 225c(S225) for 10 cycles (C10).
Your printer will now go through 10 cycles of P.I.D tuning, this will take a few minutes. Pronterface terminal will show a few lines of code for the tuning while running but will show “PID Autotune finished!” when complete.
These are the P.I.D values you need to input (please note that not all machines share the exact values and yours may differ). To input them into your printer use the command M301 P20.22 I1.22 D84.07 then M500 to save the PID to EEPROM and then M503 to verify that it is saved.
Thank you to our Tor Blazeby for writing the guide.
Unified Firmware PID Tune Menu Pictures
This work is licensed under a Creative Commons Attribution 4.0 International License.