EZOut Filament Sensor Mount for Wanhao Duplicator i3

If you are using the Wanhao duplicator i3 with our EZOut filament sensor kit you can download the STL file below to top mount the filament sensor. It needs 2x M3x25mm screws and 2x M3 nuts to secure the sensor to the bracket. We carry screw assortments with the screws...

EZABL Solid Mount Camera STL Files

If you didn’t get a camera mount with your solid mount kit or want to change your camera we have all the STL files for the camera mounts below for you to download. These are also included in the EZABL STL Files folder of our Unified Firmware download as well. GoPro...

GCode Sender – Pronterface

If you do not have Simplify3D or Octoprint and want an easy way to send GCode commands to setup the EZABL or our other products you can use the Pronterface download below. GCode Sender Download

CH340 Drivers – TH3D Uno & Creality V1.1.4 Board

Windows Download the CH340 Driver Unzip the file Run the installer which you unzipped In the Arduino IDE when the CH340 is connected you will see a COM Port in the Tools > Serial Port menu, the COM number for your device may vary depending on your system....

Creality Printer Drivers – Most Models

Most Creality Printers use a FTDI F232R USB to Serial adapter chip for them to use USB. If you have a V1.1.4 board you will want to use the CH340 Driver instead. If you are having issues communicating with your board try installing one of the drivers below. Windows...