EZABL – Setup for “Vanilla” Marlin

PLEASE NOTE: If you have a printer with the stock board the easiest and quickest setup is to use our Unified Firmware package. This guide is for people using the EZABL with a non-supported printer/board and/or those that want to use “Vanilla” Marlin with...

EZABL – Tevo Tarantula Pro Z Endstop Cable

The Tevo Tarantula Pro uses a 3 pin endstop switch on all axis. These carry the Signal, 5V, and GND lines. The 5V line is there to light up the status LED on the endstop boards. This however is not needed and must be removed before connecting the EZABL control board...

Thermistor Reading 290+C

If your printer board has the bed and/or hotend reading over 290C all the time and you have ruled out all wiring and thermistors as the issue then this means that the IO pins on the board you have are fried. This can happen to both thermistor inputs depending on the...

EZBoard Hardware Version Changelog

This is our changelog for the EZBoards by TH3D. EZBoard Lite V1.0 – First Retail Release (Batch 1) V1.1 – Cap Changed & Pullup Board for Ender 5 Included (Batch 2) V1.1 boards all ship with LCD Pullup Board for Ender 5 machines with higher than normal...