EZABL – Tevo Tarantula Pro Z Endstop Cable

The Tevo Tarantula Pro uses a 3 pin endstop switch on all axis. These carry the Signal, 5V, and GND lines. The 5V line is there to light up the status LED on the endstop boards. This however is not needed and must be removed before connecting the EZABL control board...

Z Not Showing “TRIGGERED” M119 Test

THIS ALSO APPLIES TO THE DIRECT WIRE. JUST SWAP THE 2 WIRES AND RUN THE M119 TEST AGAIN.  If you are getting a reversed TRIGGERED/open then you need to set up the firmware correctly per the directions at the top of the Configuration.h file. Issue  If your Z Endstop is...