EZABL & EZBoard – Not Triggering Fix

It’s been reported that some EZABL kits (Mostly V3 but some EZABL Pro) are not registering triggering on some EZBoards (V1.0-V1.2). This is due to the Opto IC not pulling down the voltage enough to register that it is triggered. This was not ever found to happen...

CR-10S V2.0/V2.1 Temperature Repair

This information is shared to help out the community. TH3D will NOT provide support or be liable for any damage incurred should you perform the repair. Check your printer board. If the C4 capacitor says 220 on it then you have an updated board from Creality. We...