Storing Bed Leveling Mesh & Updating Your Slicer

The EZABL and the Unified Firmware support storing your bed leveling mesh. What this means is that you only need to probe the bed initially and then you can store it so all that is needed in your starting code is G28 then M420 S1 to recall the mesh data from EEPROM. ...

Heater Recovery After G29

In the latest firmware the heaters will temporarily shut off during G28 Z and G29 to reduce electrical interference with the sensor. If your heater temps are dropping too much you can add a “wait” command after G29 to let everything heat back up. To do this add the...