Using the EZABL with CR-10S Printers with Touch LCD

The CR-10S with the touch will work with the EZABL however there are a few differences with the setup. Since the touch LCD does NOT support setting the Z offset or Babystepping you cannot do it without a computer. EEPROM: To reset the EEPROM send M502 followed by M500...

P.I.D. Auto Tune Guide

What is P.I.D. Tuning? PID (Proportional Integral Derivative) is the system the printers use for holding a set temperature. This system controls how fast the printer reaches the set temperature and how well it holds that temperature once it gets there. Without it...

GCode Sender – Pronterface

If you do not have Simplify3D or Octoprint and want an easy way to send GCode commands to setup the EZABL or our other products you can use the Pronterface download below. GCode Sender Download