Arduino IDE for Mac OS X Setup Guide

NOTE: If you are getting errors compiling for a printer with the 2560 board in it go to Tools > Boards > Board Manager. Look for ATmega2560 & revert to 1.6.21. Some users reported issues on Mac OS X with the latest 2560 board library. Installation...

EZPi Getting Started Documentation

Getting Started with the EZPi When you connect the EZPi to your machine it should automatically connect and display the IP address of your Pi on the printer LCD. If it does not you can try typing http://octopi in your browser to access it. If that fails check your...

EZOut Installation Guide

DOWNLOAD HERE: EZOut Installation Guide CR-10/Ender 3 setup are the same for the V1 and V2 EZOut kits. Read the notes in the Unified Firmware on where to Connect the Wanhao D6 and other versions that connect to a 3 pin header. “Pin 27” boards are NOT...

Storing Bed Leveling Mesh & Updating Your Slicer

The EZABL and the Unified Firmware support storing your bed leveling mesh. What this means is that you only need to probe the bed initially and then you can store it so all that is needed in your starting code is G28 then M420 S1 to recall the mesh data from EEPROM. ...