Thermistor Reading 290+C

If your printer board has the bed and/or hotend reading over 290C all the time and you have ruled out all wiring and thermistors as the issue then this means that the IO pins on the board you have are fried. This can happen to both thermistor inputs depending on the...

Using your All Metal Hotend

All metal hotends are great additions to your 3D printers. We sell our Tough All-Metal Hotend and even a Dual Hotend that all come with high-quality all-metal heat breaks. Manufacturers like E3D and MicroSwiss also sell hotends that are all-metal. No matter what brand...

Dual Extrusion Setup Information

When doing dual extrusion there are many ways to go about it. The basic requirements are that you have a board that supports 2 Extruder connections, 2 hotend connections, and 2 hotend thermistor connections. However, if you are using a 2 into 1 adapter you only need a...

P.I.D. Auto Tune Guide

What is P.I.D. Tuning? PID (Proportional Integral Derivative) is the system the printers use for holding a set temperature. This system controls how fast the printer reaches the set temperature and how well it holds that temperature once it gets there. Without it...