EZABL – Tevo Tarantula Pro Z Endstop Cable

The Tevo Tarantula Pro uses a 3 pin endstop switch on all axis. These carry the Signal, 5V, and GND lines. The 5V line is there to light up the status LED on the endstop boards. This however is not needed and must be removed before connecting the EZABL control board...

Raspberry Pi Direct Wire Power Adapter – How to connect

Video Directions: Wiring the Module Included is a length of 2 conductor wire.There is a red and black wire inside the single wire. Carefully strip the outer wire covering to expose the 2 wires inside If you do not have wire strippers you can use a razor or a sharp...

Direct Wire 12V/24V Power Info

See below for a wiring output from the CR-10 Power Supply. We recommend getting power from here. This is also applicable for MOST 12V/24V power supplies with the same connections. This is a 12V 30A PSU shown below. 24V PSUs are the same layout typically. Most PSUs...