Artillery AL-4 Full Hotend Replacement Kit

Hotend Replacement Kit for Artillery AL-4

Includes full hotend with 0.4mm nozzle, PTFE tube (0.5M), PTFE fitting, 40W 24V Heater, Thermistor, and Silicone Sock

Assembling Hotends

When installing a new hotend you must make sure is installed correctly. Please see our Hotend Assembly Guide for detailed steps and information that is important when installing a new hotend.

DIY Part Fitment/Installation/Wiring

This is a universal DIY 3D printer part. That means it will work on almost any 3D printer, but you must know what you are doing.

Our technical support does not cover selecting/designing/assisting in firmware setup and/or 3d models to install this part on your printer. If purchased as part of a kit from TH3D for a particular printer, then it will be covered under the kit when using our firmware package.

Electrical replacement parts usually will require you to splice wires into your existing ones for the part you are replacing (soldering and heat shrinking wire splices is recommended for proper connection).

Some of our universal electrical parts come with bare wire ends or plugs on them. These ends may or may not directly plug into your 3D printer. If they do not, you will need to splice the wires into the existing ones on your 3D printer.

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.