This is the printed parts ONLY. 5015 Fan Required for layer fan.
This works with the following models:
- CR-10 Mini
- CR-10 S4
- CR-10 S5
- CR-10S Mini
- CR-10S S4
- CR-10S S5
- Ender 3/3 Pro
All screws and nuts needed for this are M3 size. We carry screw assortments if you do not have extra screws. The longest screws used here are M3 x 25mm (2 for the hotend clamp). Do not use screws with a tapered head as this can break the part.
Pictures are of the actual print quality. Supports are removed before shipping. Printed at 0.2mm Layer height 35% infill.
Uses a 5015 layer fan and has a spot for our EZABL sensor. Works with our V6 hotend.
Probe offsets for firmware – This is pre-setup in our firmware already.
#define X_PROBE_OFFSET_FROM_EXTRUDER 63 // X offset: -left +right [of the nozzle] #define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
STL Files: https://www.thingiverse.com/thing:2494642
3 Months Warranty - Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link.
Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.
This design is based on the “Chito” design (we mirrored the ABL+5015 wing). We have spoken to him and he has given us the OK to sell these in the store. Check out his original mount and files here: https://www.thingiverse.com/thing:2494642
ABS Parts are BLACK.