- All the parts to add a 12864 LCD and replace the stock ABL sensor to your CR-10S Pro with NO soldering at all.
- LCD Housing (in PLA or ABS, select above)
- Screws for the 12864 LCD (M3 x 8mm)
- TH3D CR12864 LCD Adapter Board
- TH3D 12864 LCD
- Note: SD slot on LCD is not used, the SD slot on the printer board is what you will still use
- Cables for the 12864 LCD
- EZABL Pro Kit
- Cable Clips for EZABL Sensor Wire
- Bypass Jumper to disable stock ABL circuit
- CR-10S Pro EZABL Signal Wire
- Simple setup and firmware update included in our Unified Firmware to support the new LCD
- Get all the features you are missing out on with the Touch Screen
- Babystepping Z (Live Z Adjustment)
- Full ABL Probe Offset and other settings
- EStep Settings
- Acceleration/Jerk Settings
- Firmware has Thermal Runaway Protection
Installation Notes
Watch the LCD Upgrade video and follow the steps up until the firmware is installed. Then follow the EZABL Upgrade video to complete the upgrade.
LCD Upgrade Video
EZABL Upgrade Video
Warranty Information
3 Months Warranty -Â Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link.
Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.
Question
Mike Guderjohn –
The video for the firmware uses arduino to compile it, but your instructions on the FW download page tells me to use the VSCode instead. It was a pain to figure out where the configuration.h file was, but now it would be nice to know what other settings I should turn on/off based on the new LCD and moving my EZABL from an Ender 3 over to the new CR-10S Pro. The folder structure of the download for FW was different than what I go, and the infile looks to be way different than what’s in the video as well.
The printer should be here tomorrow, my order I just placed for the LCD and other things is already here, and I have a full set of Linear rails on the way.
(0) (0) Watch Unwatch
Tim Hoogland –
The videos are not able to be updated as things change with software. You should use the VSCode firmware and if you need any further help with the kit please contact our support and they’ll be happy to help you out with getting the kit installed. 🙂
(0) (0)