- 312-858-8433
- 10AM-6PM CST M-F
The essential pack to upgrade the low end PTFE parts on your Creality Printer.
From: $17.07
| Weight | 1 oz |
|---|---|
| Dimensions | 5 × 5 × 0.1 in |
| Made In | 🇨🇳 China w/QC in 🇺🇸 USA |
| Warranty Length | 6 Months |
| Weight | 1 oz |
|---|---|
| Dimensions | 0.2 × 0.2 × 0.2 in |
| Made In | 🇨🇳 China |
| Warranty Length | 6 Months |
| Weight | 1 oz |
|---|---|
| Dimensions | 0.2 × 0.2 × 0.2 in |
| Made In | 🇨🇳 China |
| Warranty Length | 6 Months |
| Weight | 3 oz |
|---|---|
| Dimensions | 3 × 1 × 1 in |
| Made In | 🇨🇳 China |
| Warranty Length | 6 Months |
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Hours – M-F 10AM to 6PM CST | Closed Weekends
Phone – 312-858-TH3D(8433)
Address – 840 S. Lake Park Ave, Hobart, IN 46342
In-Person By Appointment ONLY
My original tube kept falling out so I ordered this kit to replace the original.
Arrived fairly quickly (to Canada) and was very easy to install.
All in one pack to replace the factory PTFE tube to support hotter filament printing. Have not gotten to that yet, but I am prepared when the time comes. Only issue was I had one of the replacement M6 fittings fail pretty quickly. Just went back to stock but that does cost one star. I will note, I did not approach for a replacement as I had a solution on-hand.
The fittings work fine, definitely better than stock, though I cannot remove the tube from the hotend side without unscrewing the fitting.
The PTFE tubing, however, is TOO tight of a tolerance. With it installed on my Ender 3 V2, I suddenly have extrusion issues on large prints where I didn’t have them with looser tolerance tubing. It feels like the filament cannot be pushed through the tube as easily and the E3V2 extruder motor just can’t consistently push the filament on long extrusions.