(312) 858-TH3D (8433) Support@TH3DStudio.com

EZOut CR-10/CR-10S (All Sizes) & Ender 3 Filament Sensor Kit

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)

$19.99

This is for the CR-10, CR-10 Mini, CR-10 S4, and CR-10 S5 printers. This is now supported on the CR-10S and Ender 3 series as well.

  • TH3D EZOut Adapter Board
  • 1.75MM Filament Sensor with Status LED
    • Injection Molded ABS
    • Curved Detection Switch to Avoid filament snags
    • Brass Inlet and Outlet Bushings
    • Lightweight (1oz) For Inline Installation
  • 1 Meter Filament Sensor Cable Included
  • Firmware Included via Download
    • You will need to flash your bootloader
    • If you do not already have custom firmware on your printer you will need an Uno to flash your board.
  • Installation Guide
  • Basic Email Support Included
  • Compatible with EZABL (Direct and EZ-Connect)

Description

This is for the CR-10, CR-10 Mini, CR-10 S4, and CR-10 S5 printers. This is now supported on the CR-10S and Ender 3 series as well.

  • TH3D EZOut Adapter Board
  • 1.75MM Filament Sensor with Status LED
    • Injection Molded ABS
    • Curved Detection Switch to Avoid filament snags
    • Brass Inlet and Outlet Bushings
    • Lightweight (1oz) For Inline Installation
  • 1 Meter Filament Sensor Cable Included
  • Firmware Included via Download
    • You will need to flash your bootloader
    • If you do not already have custom firmware on your printer you will need an Uno to flash your board.
  • Installation Guide
  • Basic Email Support Included
  • Compatible with EZABL (Direct and EZ-Connect)

NOTE: This kit uses the beeper I/O Pin so you will NOT have the beeper (sounds) when using this kit. Most people do not use this or are even aware of this on their boards.

Support Level: Standard Support

Additional information

Weight2 oz
Dimensions3 x 3 x 1 in

1 review for EZOut CR-10/CR-10S (All Sizes) & Ender 3 Filament Sensor Kit

  1. Rated 5 out of 5

    JEKNAPP1 (verified owner)

    I have bought 2 sets of these EZout filament sensors.They are a must have.They work perfect and very easy to install.I highly recommend for every 3d Printer that these work with.I will buy again..

Add a review

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.