EZOut Filament Sensor Kit for MKS, SKR, and Most Creality Boards

Why do you want this upgrade?

Have you ever run out of filament during a print? Now you don’t have to worry! When you get the EZOut board and the filament sensor (add on above) you feed the filament through our sensor and when it runs out the printer will wait for you to load more filament into the printer so you can resume the print! Absolutely ZERO soldering required to install this. Easily add a filament sensor to your compatible 3D printer (see list below) today! This is a full kit that includes all the cables, heatshrink (for the ezout board), and filament sensor. You will need to update your firmware which is included via download below. This kit connects to the X+ port on supported printer boards.

Compatible Boards

• MKS SGen L V1/V2 – Connects to X+ Endstop Pin (uses LOW logic in Marlin)
• SKR E3 Mini (V1.0, V1.2, V2.0) – Connects to E-Stop Pin (uses LOW logic in Marlin)
• Creality V4.X.X Boards – Connects to J1 Header (uses LOW logic in Marlin)

Other Machines: If your printer has a MKS or SKR board that uses standard 3 pin endstop connections this will work with your board. You will need to configure your firmware for whatever pin you connect it to. Only the above machines listed have firmware pre-setup from TH3D available.

Installation Links

EZOut Installation Guide

Use our new Unified 2.0 Firmware

 

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.