Genuine Watterott TMC2208 Stepper Driver w/Heatsink


  • Genuine Watterott TMC2208 Stepper Driver
  • Heatsink Included
  • Pre-Assembled by TH3D – NO Soldering
  • Setup in standalone mode with StealthChop2
  • Quiet and near-silent stepper driver

In stock

Purchase this product now and earn 14 Benchies!
SKU: TMC2208_DRIVER Categories: ,

Product Info

  • Genuine Watterott TMC2208 Stepper Driver
    • Genuine TMC2208 Driver Chip
    • 1.2A Continuous Output
    • 2.0A Peak Output
    • 1/256 interpolated step rate
    • Works on 12V and 24V Printers
  • Heatsink Included
  • Pre-Soldered by TH3D
  • Setup in standalone mode with StealthChop2
    • Plug and play – no special configuration needed like when set in UART mode
    • Quiet operation for 3D Printing
    • No step loss like StealthChop V1
    • Automatically switches from high torque to low as needed
  • Note – We recommend these for X and Y axis and the Tough A4988 for E and Z due to lower torque on the TMC2208 drivers that can lead to missed steps on E and Z
  • Official Watterott Documentation:
  • When installing check that EN pin (marked on the top of the board) is matched up to the board you are installing this in. Installing in the wrong direction will fry the stepper driver and this is not covered under warranty.


Best Sellers

Share your thoughts!

Let us know what you think...

What others are saying

There are no contributions yet.




Your personal data will be used to support your experience throughout this website, to manage access to your account, and for other purposes described in our privacy policy.

Continue as a Guest

Don't have an account? Sign Up