Print

Ender 3 V2 – Swapping to the 12864 Creality LCD for more features

Intro

The Ender 3 V2 LCD is currently limited by its closed source firmware. You can remove the stock LCD and replace it with the Creality OEM LCD and a printed part.

Once the LCD is swapped you just flash the printer as an Ender 3, not an Ender 3 V2. This works with the Creality V4.2.X, SKR E3 Mini, and EZBoard boards when using our firmware.

LCD Screen: https://www.th3dstudio.com/product/creality-12864-oem-lcd-screen-cr-10-ender-3-ender-5-more-single-dual-cable-compatible-exp1-exp2-exp3-cables-included/ 

Mounts

Creality OEM Metal Bracket: Ender 3/Ender 3 V2 – Creality 12864 LCD Mounting Bracket – TH3D Studio LLC

Printed LCD Screen Mount (Right hand side mount): https://www.thingiverse.com/thing:4822352

Printed LCD Screen Mount (Left hand side mount): https://www.thingiverse.com/thing:3941024


Using the EZBoard with the Ender 3 V2

Once the LCD is swapped you can put our EZBoard in there and just flash it with our Ender 3 firmware setting.

EZABL Settings for Ender 3 V2 with the EZBoard

If you swap the board and are using our EZBoard with our EZABL with the Ender 3 V2 OEM EZABL mount offsets are:

#define NOZZLE_TO_PROBE_OFFSET { -48, -15, 0 }

These would get entered in the CUSTOM_PROBE section and you would also uncomment (or enable in the web config if you are using that to build the firmware) the CUSTOM_PROBE option.


Video of the Conversion

We convert ours here at timestamp 13:00

Previous Creality Ender 3 & Ender 3 Pro – Upgrades, Information, and Tips
Next Ender 5 Plus Upgrade Paths – EZABL, EZBoard, LCD Kit
Table of Contents