EStep Calculator – V1.1
This tool is to help you calibrate the ESteps for your 3D printer. Just follow the steps below to get your new ESteps. The new value can be set by sending the Gcode command below to your printer or you can also put it into your printer firmware.
If you do set the ESteps with the GCode command, remember to save it to your EEPROM by sending an M500 command after. If you do not put the EStep number into your firmware it will revert to the firmware default when you reset the EEPROM.
V1.1 – Added support for 2 decimal places on the calibration for more accuracy.