510x510mm – High Temp (140C) Magnetic Base – EZFlex Pro

Specifications

• 1mm thick magnet for high strength
• Genuine 3M 300LSE Adhesive Pre-Applied
• Rated up to 140C Bed Temperature
• This is for the MAGNET ONLY. You still need a plate and we carry them here: EZFlex Pro – Dual Sided Black Textured PEI Flex Plate
• Magnets can be trimmed or cut easily with a knife or scissors so order a size larger than your bed if you do not see your exact size, then cut to fit

Readme

• Do NOT print directly on the magnet. You must have a flex plate on top of it to use this on your printer.
• Do NOT peel the adhesive off with the backing. Make sure you are ONLY peeling the backing paper with the 3M marking on it and not the adhesive as well.
  • If you accidentally peel the adhesive off put it back on the magnet and press firmly across the entire magnet. Then use the tip of a knife or something tiny to pull just the backing paper off.
• Before installing make sure your printer bed is CLEAN and free of any debris
• Install directly on your printer bed (aluminum or glass if it is permanently attached)
• Be sure to select the correct size. TH3D is not responsible if you order the wrong size for your printer bed
• Do NOT leave liquids on the magnet or place a plate on the magnet if it is not dry and clean
• Corner style of magnet sheet may vary from picture

DIY Pricing: Support Not Included
To keep our part prices as low as possible, this item does not include technical support.

Need help installing or troubleshooting?
We offer paid Priority Email Support and Live Expert Consultations starting at just $35.