What is the M119 command? Marlin’s M119 command is called “End-stop States”. This reports the current status of each end-stop switch (and filament sensor, if present) at the time it is run. The data is retrieved by the printer and output to a terminal connected to the printer. The data typically looks like the following: […]
We’re covering setting a z offset with our EZABL probe, leveling your gantry with a dual Z printer, using babystepping, and storing changes for the probe offset to the EEPROM after making adjustments during a print.
Intro In Unified 2.26 and later we have a feature from Marlin enabled called Z Fade. This allows the firmware to gradually fade out the ABL compensation over a set distance. This distance needs to be set to an amount that gives the machine time to slowly fade off the ABL compensation. If your bed […]