Dual Z Motor Adapter Addon Board w/Cable

• Run 2 motors off 1 stepper driver
• Parallel wiring
• Compatible with EZBoard, Creality Boards, MKS Gen L, SKR, and many others that use a standard 4 pin JST XH connection
• Will reverse the Z direction of the motors – Update firmware to reflect this change. Our Unified 2 Firmware supports reversing the Z in all our builds.

Installation

1. Simply plug one end of the included cable to your printer motor connection.
2. Plug the other end into any of the 3 4 pin plugs on the Adapter board
3. Plug your 2 motors into the 2 remaining open posts on the adapter board
4. Check that the axis moves smoothly. If it does not then increase the VREF by 0.1V until the axis moves smoothly
5. Secure the board so that it cannot short out anything. Wrap with electrical tape, heat shrink, or print the case below.
   
   1. Printable Case for the board: Click here to Download the STL File

DIY Pricing: Support Not Included
To keep our part prices as low as possible, this item does not include technical support.

Need help installing or troubleshooting?
We offer paid Priority Email Support and Live Expert Consultations starting at just $35.