iWiss SN-2549 Ratchet Crimping Tools for 0.08-1.0 mm² (AWG28-18)

This is a high-quality crimp tool for most connectors we use on our 3D printers. This ratcheting type lets you get a consistent crimp and does a DOUBLE crimp in one squeeze. The handle is comfortable for repeat use. There is also a tension adjustment on the side with the silver Philips head screw.

• Crimping Range:0.08-0.5/0.25/0.5/1.0mm2,compatible with PH2.0/XH2.54/2.54/2.8/3.0/3.96/4.8/KF2510/JST Terminal
• 【Precise】Well-polished wire electrical discharge machining cutting jaw, which provides precise and accurate crimping without damage
• 【Durable】Made of premium industrial grade high strength tool steel, with special surface treatment to achieves rust and corrosion resistance, strong enough for a long service life
• 【Effortless】Smooth ratcheting mechanism and tension adjust knob save 50% effort, which is important for long time operation
• 【Ergonomic】Slight angled head design and non-slip handle makes the operation comfortable and effortless,even in wet&oil condition. With release trigger, free from stuck and snap

How to Adjust Tension

If you look at the tensioner you will see arrows with + and – on it. Turning the adjustment in the + direction is more tension and turning the adjustment in the – direction is less tension. There is a screw that holds the tensioner in place. Unscrew the philips screw and then turn the tension adjustment wheel in the – direction then put the screw back in. This will make it crimp less on the pins. If it is set too high it will mangle the pin and/or wire. Higher tension is for larger pins/wires and lower tension is for smaller pins/wires.

Works with the following type of connectors/pins

• 2.54mm
• 3.96mm
• 4.8mm
• 5.08mm
• 6.3mm
• JST Pins
• Molex Pins

DIY Pricing: Support Not Included
To keep our part prices as low as possible, this item does not include technical support.

Need help installing or troubleshooting?
We offer paid Priority Email Support and Live Expert Consultations starting at just $35.