UPDATE: We are no longer performing the board repairs.

If you are not familiar the issue is the temperatures on E0 and the Bed is unstable which causes PID tuning to fail and even heating failures. Every board will be FULLY tested before and after repair then sent back out to you. Creality has confirmed and we even have an internal memo about the V1.1.2 boards and their “fix” but they are STILL using sub-par caps to do the repair so it will not be as stable as our repair.

Below are the pics of the before and after on the 5V rail of the board. Temps are 100% stable on BOTH boards with our repair.

Affected Boards:

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.