3D Printer Belt 10mm Width – Rubber, Fiber Reinforced – 2GT/GT2 Type Belt

  • Made with actual rubber, not plastic or PU like some other belts
  • Works with most 3D printers that use belt (see below or Contact us to verify fitment)
  • Reinforced with internal fiber strands for durability and stretch resistance
  • Sold by the meter
    • When ordering more than 1 meter it will be one continuous length

$2.49

In stock

Description

  • Made with actual rubber, not plastic or PU like some other belts
    • Excellent grip and wear resistance
  • Works with most 3D printers that use belt
    • Ender 6 uses these
    • CR-10 S4 and S5 use these on Y
  • Install Notes:
    • When replacing a belt cut the new belt to the length of the old belt.
    • If your printer used crimped ends on the original belts cut the new belt 30-40mm longer.
    • Wrap the end of the belt around the belt attachment point on your carriage and fold it onto itself so the teeth mesh.
    • Then use 2x small zip ties to keep the teeth forced together and trim the excess belt length off.
    • Keep the zip ties as close to the attachment point as possible and make sure the ties will not hit anything during movement.
  • Reinforced with internal fiber strands for durability and stretch resistance
  • Specs
    • Width: 10mm
    • Pitch: 2mm
    • Type: 2GT
  • Sold by the meter
    • When ordering more than 1 meter it will be one continuous length
    • NOTE: 10 meters max continuous length
      • If you order over 10 meters please put a note in the special requests on your order as to how you want the belt cut in 1 meter increments.

 

Additional information

Weight 2 oz
Dimensions 5 × 5 × 0.1 in
Made In

πŸ‡¨πŸ‡³ China w/QC in πŸ‡ΊπŸ‡Έ USA

Warranty Length

6 Months

Reviews

There are no reviews yet.

Be the first to review “3D Printer Belt 10mm Width – Rubber, Fiber Reinforced – 2GT/GT2 Type Belt”
SHARE YOUR CART