Works with most cartridge-type hotends including our Tough Hotend V2, E3D V6, Slice Mosquito, and other cartridge-type thermistor hotends.
Not sure if this will fit your hotend? Compare your existing cartridge thermistor to the dimensions below.
Max temperature is 320C and these use Marlin thermistor #1 setting.
About 2 meter wiring with JST-XH 2 pin termination.
DIY Part Fitment/Installation/Wiring
This is a universal DIY 3D printer part. That means it will work on almost any 3D printer, but you must know what you are doing.
Our technical support does not cover selecting/designing/assisting in firmware setup and/or 3d models to install this part on your printer. If purchased as part of a kit from TH3D for a particular printer, then it will be covered under the kit when using our firmware package.
Electrical replacement parts usually will require you to splice wires into your existing ones for the part you are replacing (soldering and heat shrinking wire splices is recommended for proper connection).
Some of our universal electrical parts come with bare wire ends or plugs on them. These ends may or may not directly plug into your 3D printer. If they do not, you will need to splice the wires into the existing ones on your 3D printer.
Warranty Information
3 Months Warranty -Â Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link.
Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.
Giv Rahnema (verified owner) –
Upgraded my Ender 3 Max factory board to an SKR3 EZ and set the extruder sensor type in Klipper printer.cfg to “Generic 3950” and it matches up within .1 – .2 of the factory bed temp sensor.
(0) (0) Watch Unwatch