Why do you want this upgrade?
Have you ever run out of filament during a print? Now you don’t have to worry! When you get the EZOut board and the filament sensor (add on above) you feed the filament through our sensor and when it runs out the printer will wait for you to load more filament into the printer so you can resume the print! Absolutely ZERO soldering required to install this. Works with the stock AnyCubic Mega Zero V1 & V2 boards.
Compatible Printers
- AnyCubic Mega Zero V1
- AnyCubic Mega Zero V2
Installation Links
Use our new Unified 2.0 Firmware
FAQ
- Will my beeper still work after installing this?
- No – the pin used for the signal pin was originally used for the beeper.
- Why is there a pin missing on the header?
- This is removed so the pin does not connect to the LCD after installation and is completely normal.
Warranty Information
3 Months Warranty -Â Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.
Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.