This is just the filament sensor and the 1 meter cable. EZOut adapter board NOT INCLUDED. Works with our EZOut V1 and V2 adapter boards and EZBoard V1/V2.
These should NOT be plugged directly into your printers control board (unless you have an EZBoard as it supports this sensor). If you have a non-EZBoard printer you can get the full kits here for various printer models: EZOut – Filament Sensor Kits
TH3D EZOut V2 1.75MM Filament Sensor with Status LED
- Injection Molded PC-ABS (black)
- Curved Detection Switch to Avoid filament snags
- Tapered Inlet and Outlet
- Lightweight (1oz) For Inline Installation
- 1 Meter Filament Sensor Cable Included
- Sensor housing style may vary from what is pictured
- V2 and V3 sensors are the same sensor – The difference is the cable they come with
Pinout
- Red = VCC (3.3-5V DC)
- Black = Ground
- White = Signal
Sensor Logic Settings
- Marlin 1.1.X uses FIL_RUNOUT_INVERTING false
- Marlin 2.0.6+ uses FIL_RUNOUT_STATE LOW
Michael C. (verified owner) –
William K. (verified owner) –
You can buy these many places but I never have a quality issue buying them here.
Chaney Goldstein (verified owner) –
This has come in handy more times than I wish I could admit. It was super easy to set up and it works perfectly on the EZBoard V2. I’ve also used it on the Creality 4.2.2 board with the “J1” EZOut adapter board. Both work great and have saved many print jobs for me.
Alex Eckman (verified owner) –
Works as advertised! Stops printer as soon as filament is out. Install is easy
jbrondos (verified owner) –
The instructions: “These should NOT be plugged directly into your printer’s control board,” should be amended to read that if you have the EZBoard/Lite, there is a place on the board to plug the EZOut filament sensor directly on the board. Still, I would like to have a picture just to double-check the orientation of the plug/wires.