180x180mm – High Temp (140C) Magnetic Base – EZFlex Pro

Specifications

• 1mm thick magnet for high strength
• Genuine 3M 300LSE Adhesive Pre-Applied
• Rated up to 140C Bed Temperature
• This is for the MAGNET ONLY. You still need a plate and we carry them here: EZFlex Pro – Dual Sided Black Textured PEI Flex Plate
• Magnets can be trimmed or cut easily with a knife or scissors so order a size larger than your bed if you do not see your exact size, then cut to fit

Readme

• Do NOT print directly on the magnet. You must have a flex plate on top of it to use this on your printer.
• Do NOT peel the adhesive off with the backing. Make sure you are ONLY peeling the backing paper with the 3M marking on it and not the adhesive as well.
  • If you accidentally peel the adhesive off put it back on the magnet and press firmly across the entire magnet. Then use the tip of a knife or something tiny to pull just the backing paper off.
• Before installing make sure your printer bed is CLEAN and free of any debris
• Install directly on your printer bed (aluminum or glass if it is permanently attached)
• Be sure to select the correct size. TH3D is not responsible if you order the wrong size for your printer bed
• Do NOT leave liquids on the magnet or place a plate on the magnet if it is not dry and clean
• Corner style of magnet sheet may vary from picture