Why do you want this upgrade?
The Ender 5 Plus has a touchscreen from the factory. This may look pretty with its color graphics but you’re missing out on a lot of control and features (like live Z adjustment) by using the stock screen. When you add this to your Ender 5 Plus you get access to the FULL LCD menu system available on our Unified 2 Firmware (built on Marlin) with no limitations. You get more control over the BLTouch sensor that comes on the printer and you can even upgrade to our EZABL if you’re not happy with the stock BLTouch.
Running an aftermarket board? This kit works with the stock control board (V4.2.2 version) and with our EZBoard products.
- Creality V4.2.7 – Firmware: Creality Ender 5 Plus Firmware – V4.2.7 Board – TH3D Studio Help Center – (BLTouch requires 10-pin Extension Cable)
- BTT SKR E3 Mini V1 – Firmware: Creality Ender 5 Plus Firmware – SKR E3 Mini V1/V1.2/V2 Board – TH3D Studio Help Center
- BTT SKR E3 Mini V1.2 – Firmware: Creality Ender 5 Plus Firmware – SKR E3 Mini V1/V1.2/V2 Board – TH3D Studio Help Center
- BTT SKR E3 Mini V2 – Firmware: Creality Ender 5 Plus Firmware – SKR E3 Mini V1/V1.2/V2 Board – TH3D Studio Help Center
- BTT SKR E3 Mini V3 – Firmware: Creality Ender 5 Plus Firmware – SKR E3 Mini V3 Board – TH3D Studio Help Center
- EZBoards V1 & V2 – Firmware: EZFirmware.TH3DStudio.com
Have questions about this upgrade? Contact our support team and we’ll be happy to assist!
Will this work with Klipper?
Yes, these LCDs and the stock board are supported by Klipper firmware. However, due to the complexity of Klipper, our technical support that is included does NOT apply if you are using Klipper firmware. Technical support only applies when you are using our Unified 2 Firmware package that is included.
Design Note: Housing design may be slightly different than shown in the pictures and/or videos as we make improvements to the design as we get feedback from customers.
Key Features
- Babystepping Z (Live Z Adjustment)
- Full ABL Probe Offset and other settings
- EStep Settings
- Acceleration/Jerk Settings
- Firmware has Thermal Runaway Protection
What is included?
- Printed LCD housing – Made in the USA with ABS Plastic
- Screws for the 12864 LCD
- Screws and TNuts to Mount the LCD to the Ender 5 Plus (M4x10mm + M4 TNuts, 3 sets total)
- 12864 LCD Screen with Cables and Knob
- Note: SD slot on LCD is not used and is covered up in our LCD housing design to prevent confusion, the SD slot on the printer board is what you will still use
- Simple setup and firmware update included in our Unified 2 Firmware to support the new LCD
Thomas Moore (verified owner) –
Now I have full view of my of all the settings for my Ender 5 Plus. Unlike what I get from original load from Creality
Travis Solomon (verified owner) –
Have all the menus needed for UBL unlike the stock display