Why do you want this upgrade?
Have you ever run out of filament during a print? Now you don’t have to worry! When you get the EZOut board and the filament sensor (add on above) you feed the filament through our sensor and when it runs out the printer will wait for you to load more filament into the printer so you can resume the print! Absolutely ZERO soldering required to install this. Works with the V1.1.X and V4.2.X Creality Boards
- Creality Ender 3
- Creality Ender 3 V2 (when LCD is swapped) – See here for details: Ender 3 V2 – Swapping to the 12864 Creality LCD for more features – TH3D Studio LLC
- Creality Ender 3 Pro
- Creality Ender 5
Use our new Unified 2.0 Firmware
You need a bootloader on your board to use this product. The V4.2.X boards already have a bootloader.
You can add on a bootloader kit above and there is a very easy to follow guide with a video on our page here: 1284p Printer Bootloader Flashing Video Guide – CR-10/Ender 2 3 5/Wanhao i3/Anet
- Will my beeper still work after installing this?
- No – the pin used for the signal pin was originally used for the beeper.
- Why is there a pin missing on the header?
- This is removed so the pin does not connect to the LCD after installation and is completely normal.
Warranty & Support Information
TH3D Community Support - Technical support with for product it is handled through our TH3D Communities. You can get access to them on our Community Page. If you require tech support direct from the TH3D team to use/install the part it is available for an additional, hourly charge.
3 Months Warranty - Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. This is for warranty related issues only, not technical support. Damage/Failure due to improper installation, usage, failure resulting from an issue with the machine the product is installed on, and/or modification or the product is not covered under warranty