EZFlow Nozzles for Ender 3/3 Pro – Copper, High-Flow, & Wear-Resistant

Made from a high temp copper alloy (max temp is 500C) & Plated with our Tough Plating for wear resistance and a smooth filament flow. Print at higher speeds due to up to 3X the heat transfer of brass nozzles and over 6X the heat transfer of steel nozzles. 

Tested in-house to stand up to the toughest abrasive filaments like Carbon Fiber and Glow in the Dark. These nozzles conduct heat so well that it is recommended to lower your normal printer temperature by 10C. 60-degree internal nozzle angle for optimal filament flow

Each quantity is for ONE nozzle. Nozzle Appearance may vary from picture. Plating and copper core are all the same between nozzle designs.

Installation Notes

• These nozzles are copper which means they are softer than brass or steel nozzles.
  • Do NOT over-tighten them when installing them
  • Apply as much pressure when tightening as you can with ONE finger
• Heat the hotend to 240C when removing and installing nozzles.

Installation Video

Warranty Information

3 Months Warranty -  Our warranty covers any and all defects with the product. If your product fails or has problems within the warranty period you can contact our support team by using the Contact Us link. Technical support is limited to the scope of the product itself and not your entire machine.

Damage/Failure due to improper installation, improper usage, failure resulting from an issue with the machine the product is installed on, 3rd party products connected to our product, and/or modification of the product are not covered under warranty.