- 312-858-8433
- 10AM-6PM CST M-F
Replaces the stock nut to remove slop that the stock nut has & prevents Z gantry from dropping down when motors turn off. Fits many Creality and Sovol Models. See below for a full list of verified printers these work on.
$5.99
In stock
Prevents Z gantry from dropping down when motors turn off. Includes nut with 2 pieces and steel spring – One nut needed for each leadscrew on Dual Z Motor printers.
Every single nut is test-fitted to a leadscrew before shipment to ensure smooth operation and proper fitment. If you order multiple do NOT mix the pieces from each package. The bottoms and tops are matched and may not fit if you swap them.
This fits the above machines with the 2 Screw leadscrew nuts. This does NOT fit standard 4 bolt leadscrew nut mounts (like Ender 5 and Tevo Tornado) due to spacing being different on these.
Leadscrew Fitment: These fit 4 start, 8mm leadscrews.
Using the TH3D Ender 3/CR-20 Dual Z Kit? – Use ONE with the TH3D Ender 3 Dual Z Kit on the motor side. Using 2 can make adjusting the system for smooth movement difficult. It is recommended to only use one with our dual Z kit.
| Weight | 1 oz |
|---|---|
| Dimensions | 1 × 1 × 1 in |
| Made In | 🇨🇳 China |
| Warranty Length | 6 Months |
That is because this product is not sold for the SV06 series. It is only verified to fit the SV01 and SV03 models.
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Hours – M-F 10AM to 6PM CST | Closed Weekends
Phone – 312-858-TH3D(8433)
Address – 840 S. Lake Park Ave, Hobart, IN 46342
In-Person By Appointment ONLY
Have seen significant improvement in prints with this as I was having issues where the layers seem to be squished and others were not. After this simple upgrade, all that went away.